|
|
新建网页 1
220V Industrial Steam Iron Curtain
Electric Iron Boiler Pressurized 3.5L Tank
 |
| The steam iron is equipped with a 3.5L
high-capacity water tank for continuous steam output, allowing extended
operation to meet bulk ironing demands. It is suitable for diverse
applications including garment shops, hotels, and household use. |
| Voltage: |
220V, 50/60HZ |
| Water Capacity: |
0.9Gal (3.5L) |
| Steam pressure: |
2.5 bar |
| Min. Steam Output
Time: |
About 4 Hours |
| Boiler Resistance
Power (220V): |
1600 Watt |
| Iron Resistance
Power (220V): |
900 Watt |
| Liner Material: |
Stainless Steel |
| Package size: |
14.0"*12.8"*21.2"
(35.5cm*32.5cm*54cm) |
| Net weight / Gross
weight: |
24.2lbs(11kg) / 30.8lbs(14kg) |
Security
Alerts
1. The device operates on 220 V voltage.
2. The power outlet used must be properly grounded.
3. Never use electrical equipment with damaged cords, and always replace
any damaged wiring. Similarly, if the steam hose is damaged and leaks
steam, you may contact us for assistance if needed.
4. Avoid direct contact with the iron's soleplate during use, as it
reaches extremely high temperatures. The recommended silicone ironing
mat may also become hot after prolonged use - exercise caution when
handling.
5. The device continuously generates intense and high temperature
steam. Always prevent steam from directly
contacting skin during operation.
6. Keep children away from the device, especially while it is powered on
and in active use.
7. Always unplug the device when not in use. Leaving it connected to a
power outlet unattended may pose safety hazards, especially for
children.
8. Exercise caution when moving the device. Improper handling may cause
damage to the equipment.
9. Do not immerse the device in water or any other liquid.
10. Never open the water tank cover while the device is operating.
11. After refilling water, do not overtighten the tank cover. If the
cover becomes damaged due to excessive tightening, please replace it
with a new one.
12. Always unplug the device from the power outlet before performing any
water refilling or draining operations on the tank.
13. If the water in the tank runs out during ironing (indicated by the
boiler power light turning off) but you need to continue ironing:
First, turn off the power.
Do not open the water tank cover immediately, as residual steam may
still be present. Slowly open the lid until steam begins to escape, then
pause and wait for all remaining steam to dissipate completely. Once the
steam is fully released, open the lid and refill with an adequate amount
of water.
Warning: During this process, hot water may splash out due to
the remaining heat in the steam boiler. Proceed with caution.
DO NOT TRY TO REPAIR YOUR DEVICE YOURSELF IN CASE OF MALFUNCTION!!!
DO NOT OPEN THE INSIDE!!! |
| Product Features & Advantages |
|
1. The device comes in a steam boiler system made
of stainless steel, the water tank is 3.5L, and on iron attached to it.
Pressurized steam that the resistance creates by boiling the water in
the boiler; it moves by pressing the control button on the iron and
allows perfect ironing from the heat resistant silicone hose and
afterwards through the hot channels in the iron and out from the holes
of the iron base.
2. As long as the steam control knob is pressed, the water in the boiler
is constantly steamed at 2.5-3 bar pressure.
3. 4-stage safety system.
4. The Boiler Resistance Power is 1600 Watt, and the Iron Resistance
Power is 900 watts per unit. Provides constantly pressurized and dry
steam, allowing you to iron quickly and therefore consume less energy.
5. The device works with 220 Volt 50/60 Hz electric energy. |
|
1. Make sure the boiler is not connected to power.
Remove the water tank cover by turning it counterclockwise. Using the
funnel and measuring glass in the Super Mini Box, put into enough tap
water to reach the device capacity. You can adjust water volume by using
the measuring glass.
2. The scaled water level tube available in your
box should be placed vertically down the water inlet hole, with the
scaled side of tube down and the water tube touching the bottom of tank.
Remove the tube by clogging the top
hole with your finger. You will see that there is enough water in the
level tube to show the amount of water in the
tank. Make sure that the level of water in the tube does not exceed the
level of 1 liter. If the level is above 1 liter,
please drain excess water.
3. Make sure that the buttons on the front panel of
the device are in the off position. Plug the power plug into a grounded
electrical outlet nearest to you.
4. STEAM IRONING: Set the two buttons on the front
panel of your Super Mini to the open position. Set the thermostat knob
to a temperature suitable for the fabrc you are ironing.
For the device to be ready for ironing: wait for the steam lamp on the
front panel to light up. (It needs about 10-15
minutes).
During this standby, assemble the two-piece wire holding fork and place
it in its position. Route the iron cable property through the hole in
the top of the wire holding fork.
5. When the steam lamp lights up, it means that
your device is ready to iron.
6. Now you can start enjoying a pleasant ironing.
With the intense and continuous steam delivery of the device, you can
iron all kinds of fabrics professionally and effortlessly in a short
time. During use, you can put the iron on the ironing rest on the
device.
Please note: After purchase, we will provide you
with a user manual (including warnings and tips) to ensure quick mastery
of core functions. Please read the instructions carefully. |
 |
1. Boiler body
2. Steam iron power switch
3. Boiler power switch
4. Steam warning lamp
5. Water warning lamp
6. Safety valve
7. Wire and steam hose connection
8. Wire holding fork
9. Micro switch
10. Thermostat set
11. Iron rest
12. Steam pressure gauge
|
| Product Presentation & Details |
|
220V Industrial Steam Iron Curtain
Electric Iron Boiler Pressurized 3.5L Tank *1 |
You can make order with no
worry.
Any concern just feel free to let us know, we'll reply in 24 hours in
normal condition.
Handling Time: Shipping is usually made in 1-3 business days after
payments cleared. Orders are processed from Monday-Friday; Not on the
weekends & public holidays.
Warranty: 6 months' warranty for the machines, not for the consumables.
We stand behind our products all the item, so even if your warranty
period has expired, you can still seek for service or technical support
from us with low cost. |
|
|
|
无标题文档
|
|
