|
1. Prepare
a bucket of water, the steam generator pumping pipe and filter into the
bucket, preferably close to the bottom of the water.
2. Connect
the power supply.
3. Push the
air knife on the right side of the machine, press the boiler heating
switch, and the indicator light will turn on. If the water inside the
generator is not enough, the solenoid valve will be automatically opened
to control the pump and start pumping. When the water level reaches the
set water level, the pump will automatically stop working and the
heating pipe will begin to heat. The heating indicator lights up until
the generator reaches the rated pressure.
4. Connect
the iron air connector and steam pipe, lock back the connector, and
tighten the steam pipe.
5. Open the
heat switch of the iron, press the steam switch on the iron handle, the
solenoid valve begins to provide steam, and the temperature of the iron
can be adjusted by the knob.
6. The
pressure gauge on the front can check the real-time steam pressure.
Water level controllers and probes ensure that water levels are kept
within reasonable limits.
7. When the
pressure is too high, the spring safety valve opens to reduce the
pressure inside the generator.
|
